Avaya P580 - Manual (Page 494)

14-2 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
2. Refer to Table 6-79 to configure the IPX SAP Interface
dialog box parameters:
Table 6-79. IPX SAP Interface Dialog Box Parameters
Parameter Allows you to...
Select Select a SAP interface to modify.
Interface Identifies the IPX interface associated with the
SAP interface.
Network Number Identifies the number of the IPX network
associated with the interface.
Use Interpacket
Gap Select one of the following from the pull-down
menu:
• Disable – if you do not want the IPX SAP
periodic update packets to be sent out over
an interface with no interpacket
transmission delay.
• Enable – If you want to send the IPX SAP
periodic update packets to be sent out over
an interface with an interpacket transmission
delay (default).
Use Max Packet
Size Select one of the following from the pull-down
menu:
• Disable – To limit SAP packets to 7 service
entries(default).
• Enable – To allow SAP) packets to contain
the maximum number of services entries
that are allowed by the SAP Interface MTU
(default).
Periodic Update
Interval (sec) Enter (in seconds) the interval at which periodic
SAP updates are sent out an interface.Default is 60
seconds.
Aging Interval
Multiplier Enter the length of time that information from
received SAP updates are kept as a multiplier of
the Periodic Update Interval.Default is 3.
Triggered Updates Select one of the following from the pull-down
menu:
• Disable – To prevent SAP updates from
being immediately transmitted to the
network in response to changes in the
network topology
• Enable – To allow SAP updates to be
immediately transmitted to the network in
response to changes in the network topology
(default).