Avaya P580 - Manual (Page 717)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 B-3
Boot Mode
gateway) to the ethernet console port prior to
attempting the TFTP download of a new operational
image.
1. Ensure the ethernet console port is connected to the network
for a TFTP transfer (refer to the Command Reference Guide for
the Avaya P550R, P580, P880, and P882 Multiservice Switches,
Version 5.3.1, “Chapter 3, Configuration”).
2. Enter the following command to assign an IP address to the
ethernet console port:
Boot> ip address <ip address> <ip mask>
3. Enter the following command to assign a default gateway to
the ethernet console port (if necessary):
Boot> ip default_gateway <ip address>
4. Enter the following command to download new operational
code to APP1 or APP2:
Boot> download <app1|app2> <serverIP> <filename>
5. Enter the following command to set the switch to boot from
the appropriate image stored in APP1 or APP2
Boot> feprom set <app1|app2>
6. Enter the following command to reset the switch:
Boot> reset