Avaya P580 - Manual (Page 422)

11-4 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Chapter
2. Refer to Table 6-53 to configure the OSPF Global
Configuration dialog box parameters:
3. Click APPLY to save changes, or CANCEL to restore
previous settings.
Table 6-53. OSPF Global Configuration Dialog Box Parameters
Parameter Allows you to...
OSPF Select to enable or disable OSPF globally on your switch.
Router ID Specify the Router ID on the switch. The router ID is a
32-bit number assigned to each router running OSPF.
This number uniquely identifies the router within an
Autonomous System. If 0.0.0.0 is used, the router uses
the IP address of an interface.
AS Border
Router Enable or disable the switch to be an Autonomous
System Border Router (ASBR).
SPF Hold
Time Specify the minimum number of seconds between SPF
(shortest path first) runs.
SPF Suspend Specify the number of nodes to process SPF runs before
suspending.
Auto-
Creation of
Virtual Links Enable or disable the function of automating the
creation of virtual circuits based on network topology.
This feature is Avaya proprietary and only auto creates
virtual links on the config. notes.
Maximum
Number of
Paths Configure the maximum number of paths used when
running OSPF.
Local Ext
Type Specify whether imported local routes are advertised in
OSPF with type 1 (internal) or type 2 (external) metrics.
RIP Ext Type Specify whether imported RIP routes are advertised in
OSPF with type 1 (internal) or type 2 (external) metrics.
Static Ext
Type Specify whether imported high preference static routes
are advertised in OSPF with type 1 (internal) or type 2
(external) metrics.
Static Low
Ext Type Specify whether imported low preference static routes
are advertised in OSPF with type 1 (internal) or type 2
(external) metrics.