Avaya P580 - Manual (Page 603)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 18-3
Monitoring and Configuring the Forwarding Cache
3. Click:
— APPLY to save your changes
— CANCEL to restore previous settings
— REFRESH to update your system configuration
— CLEAR to reset all configuration parameters to zero.
Using the CLI
To configure the forwarding cache using the CLI, enter the following
command from Configure mode:
<configure># ip multicast route-cache <options>
<configure># ip unicast route-cache <options>
Table 6-116. Layer-3 Forwarding Cache Configuration Dialog Box
Parameters for Tree Configuration
Tree Configuration
Field... For the
protocol... Allows you to...
Hash Mode IP Unicast
(IPU)
IP Multicast
(IPM)
IPX
Configure the table hash lookup mode for
the IP unicast, IP multicast and IPX
protocols. The options are:
• DA-only - Forwarding entries
input to the forwarding table are
limited to using protocol destination
address only.
• SA-DA - Forwarding entries input
to the forwarding table are limited
to using destination and source
address only.
Aging IP Unicast
IP Multicast
IPX
Configure the IP unicast, IP multicast, or
IPX protocols forwarding table entry
aging status as either Enable (default)
or Disable.
Age
Interval IP Unicast
IP Multicast
IPX
The IP unicast, IP multicast, or IPX
protocols forwarding table entry aging
period (in seconds). The valid range is 20-
360 seconds. The default value is 120
seconds.
Maximum
Entries IP Unicast
IP Multicast
IPX
The number of active entries in the IP
unicast, IP multicast, or IPX protocol
forwarding table. This is the maximum
number of active entries per fabric port.
Additional flows are forwarded by the
supervisor module. The default value is
15000.