Avaya P580 - Manual (Page 710)

Appendix A
A-8 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
configuration file to the startup configuration file. This
ensures that the changes persist after the switch is restarted.
When your switch is configured with a redundant supervisor,
you must also synchronize the supervisor modules in order
for both to have the same configuration and reset the
standby.
Resetting the Active Supervisor
After setting the switch to load the new software at startup, you
must reset the switch. You can use either the Web Agent or CLI to
perform this task.
If the switch has a redundant supervisor module, resetting the
Active supervisor to load the new boot and application code forces
the Active supervisor to Standby, and the Standby supervisor to the
Active Supervisor mode. See, “Reset the Standby Supervisor”, next
to change the Supervisor modes back to their original state.
Web Agent
Procedure
To reset the switch after downloading new application software:
1. In the navigation pane, expand the System folder.
2. Select System Reset.
The System Reset Web page is displayed in the content
pane (Figure A-3).