Avaya P580 - Manual (Page 636)

19-24 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
6. Adjust the trap timer, if desired.
See “ Configuring Switch Port Parameters ” in Chapter 5,
“Configuring Port Parameters,” for information on how to
perform these procedures.
7. Click Apply.
CLI Commands
To use the CLI to enable the MAC Address Lock feature and traps for
unknown source addresses:
1. Enter Global Configuration mode.
The CLI displays the <configure># prompt.
2. Use the following command to manually add the “permitted”
MAC addresses to the Address Forwarding Table (AFT):
set aft entry <mac address> vlan <vlan-id> port-binding
forward <mod-port-spec>
3. Use the following command to disable learning on a port or
port range:
set port allow-learning <mod-swport-range> disable
4. Use the following command to enable known mode on a port
or port range:
set port known-mode <mod-swport-range> enable
* Note: To prevent the flooding of frames that have
unknown destination addresses, enter all ports
on the same VLAN as the port for which you are
enabling MAC address lock.
5. Use the following command to enable intrusion traps on a
port or port range:
set port intrusion-trap <mod-swport-range> enable
6. Use the following command to set the intrusion trap timer to
other than the default setting:
set port intrusion-trap-timer <mod-swport-range>
<intrusion-trap-timer-value>