Avaya P580 - Manual (Page 514)

15-8 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Figure 6-121. AppleTalk Interfaces
Using the CLI
Use the following CLI commands in interface mode to create an
AppleTalk interface:
(config if-:<interface-name>)# appletalk cable-range <cable-
range>
(config if-:<interface-name>)# appletalk address
<network.node>
(config if-:<interface-name>)# appletalk zone <zone-name>
(config if-:<interface-name>)# appletalk vlan <vlan-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Editing AppleTalk Interfaces
You can edit AppleTalk interfaces using either the Web Agent or the
CLI.
Using the Web
Agent
To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an
AppleTalk interface before you can edit an interface. See
"Enabling AppleTalk Global Routing" and "Creating an
AppleTalk Routing Interface", earlier in this section.
1. Select Interfaces from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Interfaces dialog box opens (Figure 6-123).
2. If there is no zone to select or if you want to edit the zones
available, complete this step through step x. If not, skip to
step x+1. Select Edit Zone to edit the AppleTalk zone for this
interface. The Edit AppleTalk Zone dialog box opens
(Figure 6-122).