Cli command – Avaya P580 User Manual
Page 709
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
A-7
Upgrading the Application Software
The FEPROM Contents Web page is displayed in the
content pane (Figure A-183).
3. In the Power Up/Reset Image field, select the APP location
to which you downloaded the new application software.
4. Select APPLY.
CLI Command
To set the switch to load the new software at startup, use the
following CLI command:
<configure># boot system flash {app1 | app2 | cardapp1 |
cardapp2}
For more information on this command, see Chapter 27, “System,”
in the Command Reference Guide for the Avaya P550R, P580, P880, and
P882 Multiservice Switches.
Synchronizing the Active and Standby
Supervisor Modules
If the switch has a redundant supervisor module, you must
synchronize the active and standby supervisor modules after you
upgrade the application software on the active supervisor module.
During this synchronization, the new boot code and application
software are copied to the standby supervisor module.
For information on how to synchronize the active and standby
supervisor modules, see
“Synchronizing the Active and Standby
CAUTION
The Avaya Multiservice Switch must have the same model
supervisors in slots 1 and 2 to support redundant supervisor
operation. Both Active and Standby CPUs app1 and app2
images must run 5.0 or greater software to support 80-series
Supervisor.
CAUTION
The Standby supervisor module must use the same boot code
as the Active Supervisor module and must be running in the
same Fabric mode.
CAUTION
When making configuration changes to the switch you must
save the changes you made by copying the running