Avaya P580 - Manual (Page 415)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1 10-11
Configuring the Routing Information Protocol (RIP)
Table 6-51. Key Chain Parameters
2. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Using the CLI
To assignor modify Key Chain parameters using the CLI, enter the
following commands from router:rip mode:
To create the Key Chain:
(configure router:rip)# key chain <Key Chain>
To set the Key Chain ID:
(configure router:rip)# key <Key ID>
To set the Key Name (MD5 Key):
(configure router:rip)# key-string <Key Name>
Parameter Defines the...
Key Chain 1-16 character ASCII name of the Key Chain
Key ID Three digit number of the Key. Valid range 1 to 255.
Key Name 16 character alpha-numeric key. This is the actual
key used by MD5 encryption. This setting must be
identical to the Key on other RIP V2 routers on the
same subnet. To be compatible with Cisco devices,
do not use a digit (0 - 9) as the first character.
Key Accept
Time:hour The hour(1-23) this key becomes valid
Key Accept
Time:minutes The minute(0 - 59) this key becomes valid
Key Accept
Time:seconds The second(0 - 59) this key becomes valid
Key Accept Year The year (2000 - 2009) this key becomes valid
Key Accept
Month The month (1 - 12) this key becomes valid
Key Accept Day The day (1 - 31) this key becomes valid. If you enter
a day that does not exist in a month such as the 31st
of February, the Key will not be created.
Key Accept
Duration The duration in seconds that this key is valid. Enter
-1 if the key is to last indefinitely.