Avaya P580 - Manual (Page 407)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1 10-3
Configuring the Routing Information Protocol (RIP)
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring RIP
on the Switch
Using the CLI
To configure or modify the RIP parameters globally on your switch
using the CLI, enter the following command in router:rip mode:
(configure router:rip)# timers basic
<update><invalid>
Update Timer <Msec> <Range:Min=10,Max=50>
(configure router:rip)# output-delay <delay>
(configure router:rip)# triggered updates <CR>
<enable,disable>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about these
commands.
Triggered
Updates Disable or Enable route updates that were triggered by a
topology change in the network to be added to the routing
table. The default is Enable.
Update Pkt
Delay Enter the value (in seconds) that represents the time delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 1
second. The parameter range setting is 0-50 seconds.
Table 6-49. RIP Global Configuration Dialog Box Parameters continued
Parameter Allows you to...