Avaya P580 - Manual (Page 256)

6-26 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
Chapter
4. Set the Known Mode field to Enable.
* Note: To prevent the flooding of frames that have
unknown destination addresses, set the Known
Mode field to Enable for all ports on the same
VLAN as the port for which you are enabling
MAC address lock.
5. Set the Intrusion Trap field to Enable.
6. Adjust the trap timer, if desired.
For information on how to adjust the trap timer, see
“Configuring Switch Port Parameters” on page 24.
7. Click Apply.
CLI Commands
To use the CLI to enable the MAC Address Lock feature and traps for
unknown source addresses:
1. Enter Global Configuration mode.
The CLI displays the Avaya (configure)# prompt.
2. Use the following command to manually add the “permitted”
MAC addresses to the Address Forwarding Table (AFT):
set aft entry <mac address> VLAN <VLAN-id> port-
binding forward <mod-port-spec>
3. Use the following command to disable learning on a port or
port range:
set port allow-learning <mod-swport-range> disable
4. Use the following command to enable known mode on a port
or port range:
set port known-mode <mod-swport-range> enable
* Note: To prevent the flooding of frames that have
unknown destination addresses, enter all ports
on the same VLAN as the port for which you are
enabling MAC address lock.
5. Use the following command to enable intrusion traps on a
port or port range:
set port intrusion-trap <mod-swport-range> enable