Avaya P580 - Manual (Page 381)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 9-95
Configuring IP Routing
* Note: For VRRP to function correctly, it must be enabled
globally and enabled on the interfaces on which any
virtual routers are to be created. Otherwise, any virtual
routers created will be in the Initialize state (see State in
table 8-3).
Using the Web
Agent
To enable an VRRP on an interface using the Web Agent:
1. Select Interfaces from the Routing > IP > Configuration
group on the Web Agent window. The IP Interfaces dialog
box opens (Figure 6-62).
* Note: Due to the length of the IP Interfaces dialog box,
it is divided into two figures in Figure 6-62.
Figure 6-62. IP Interface Dialog Box
2. Select the interface on which you want VRRP to be enabled.
3. Select Enable from the VRRP field pull-down menu for the
interface you selected.
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
CLI Command
To enable an VRRP on an interface using the CLI, enter the
following command in Configure/Interface mode:
<config-if:<if name>># ip vrrp
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.