Avaya P580 - Manual (Page 524)

15-18 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Editing an AppleTalk NBP Filter
You can edit an AppleTalk NBP filter using either the Web Agent or
the CLI.
Using the Web
Agent
To edit an AppleTalk NBP filter using the Web Agent:
1. Select NBP Filter from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk NBP Filter dialog box opens (Figure 6-132).
Figure 6-132. AppleTalk NBP Filter
2. Refer to Table 6-85 to edit the AppleTalk NBP Filter dialog
box parameters.
3. Click:
— CREATE to add a new filter. The Add AppleTalk NBP
Filter dialog box opens. See “Creating an AppleTalk NBP
Filter”, earlier in this section, for more information.
— DELETE to remove the selected NBP filter.
— CANCEL to restore previous settings.
— Edit If to add or delete this NBP filter to/from an
interface. The Add/Delete Interface to NBP Filter
dialog box opens. See “Adding or Deleting Interfaces to
NBP Filter”, later in this section, for more information.
Using the CLI
To edit an AppleTalk NBP filter using the CLI, enter the following
command in Interface mode:
(config-if <interface-name>:)# appletalk access-
list <access-list-number> <permit | deny> nbp
<string>