Displaying router ports, Displaying router ports -8, Using the cli – Avaya P580 User Manual
Page 550: Using the web agent
16-8
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Using the CLI
To configure intelligent multicasting globally using the CLI, enter
the following command from Configure mode:
<configure># set intelligent-multicast {enable}
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Displaying Router Ports
You can display router ports using either the Web Agent or the CLI.
Using the Web
Agent
To display router ports using the Web Agent:
1. Select Global Configuration from the L2 Switching >
Intelligent Multicast group on the Web Agent window.
The Intelligent Multicast Global Configuration dialog
box opens (Figure 16-2).
* Note: You must enable intelligent multicasting on a
global basis to make your router ports active.
See “
Configuring Global Intelligent
”, earlier in this chapter.
2. Select Display/Configure Router Ports. The Router Port
Display/Configuration dialog box opens (Figure 16-3).
Figure 6-146. Router Port Display/Configuration Dialog Box