Avaya P580 - Manual (Page 435)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1 11-17
Configuring the OSPF Routing Protocol
Deleting OSPF
Virtual Links
Using the CLI
To delete an OSPF virtual link using the CLI, enter the following
command from Enable/Configure mode:
(configure router: ospf)# [no] area <area-
id> virtual-link <router-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
Modifying OSPF Virtual Links
You can modify OSPF virtual links using either the Web Agent or
the CLI.
Using the Web
Agent
To modify an OSPF virtual link using the Web Agent:
1. Select Virtual Links from the Routing > IP > OSPF group
on the Web Agent window. The OSPF Virtual Links dialog
box opens (Figure 6-82).
2. Select the virtual link that you want to modify.
3. Refer to Table 6-56 to modify the OSPF Virtual Links dialog
box parameters.
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Using the CLI
To modify an OSPF virtual link using the CLI, enter the following
command and make your desired changes from Configure mode:
(configure router: ospf)# area <area-id> virtual-
link <router-id> [hello-interval <seconds>]
[retransmit-interval <seconds>] [dead-interval
<seconds>] [{authentication-key <key> | message-
digest-key <key-id> md5 <key>}]
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.