Avaya P580 - Manual (Page 453)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1 11-35
Configuring the OSPF Routing Protocol
CLI Commands
To use the CLI to set up an NBMA IP interface:
1. Enter Configuration mode. The CLI displays the following
prompt:
<configure>#
For information on how to enter this mode, see “Accessing/Exiting
the Command Modes” in Chapter 1, “Overview,” of the Command
Reference Guide for the Avaya P550R, P580, P880, and P882 Multiservice
Switches, v5.3.
2. Enter the following command at the prompt:
<configuration># interface <interface-name>
The following prompt displays:
(configure-if:<interface-name>)#
3. Enter the following command at the prompt:
(configure -if: <interface-name>)# ip address <ip-addr>
<mask>
4. Enter the following command at the prompt:
(configure -if: <interface-name>)# type nbma
Setting Up NBMA Neighbors
Web Agent
Procedure
To use the Web Agent to set up NBMA neighbors:
1. Open the Routing > IP > RIP or OSPF folders, whichever
one was created with an NBMA type interface.
2. Click NBMA Neighbors. The RIP or OSPF NBMA Neighbors
Web page opens.
3. Click Create. The Add NBMA RIP or OSPF Neighbor Web
page opens.
4. Enter a neighbor IP interface address in the Network
Address field.
5. Click CREATE, or CANCEL to restore previous setting.