Avaya P580 - Manual (Page 495)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 14-3
Configuring IPX SAP Protocol
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring IPX
SAP Interfaces
Using the CLI
To configure the IPX SAP interfaces using the CLI, enter the
following command from Interface mode:
(config-if <interface-name>):# ipx sap
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Creating IPX SAP Filters
This section provides the following procedures:
■
Creating IPX SAP Name Filters
■
Creating IPX SAP Network Filters
Get Nearest Server
Reply Select one of the following from the pull-down
menu:
• Disable – To prevent the router from
responding to Get Nearest Server requests
received on the interface
• Enable – To allow the router to respond to
Get Nearest Server requests received on
the interface (default).
Get Nearest Server
Reply Delay(msec.) Specify the delay (in msecs) to wait before
responding to a Get Nearest Service request
received on the interface.Default is 0.
Mode Select one of the following from the pull-down
menu:
• Talk/Listen - Send and receive
advertisements (default).
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
Table 6-79. IPX SAP Interface Dialog Box Parameters continued
Parameter Allows you to...