Creating an appletalk static route, Creating an appletalk static route -11, Using the cli – Avaya P580 User Manual
Page 517: Using the web agent
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
15-11
Configuring AppleTalk Routing
Figure 6-124. AppleTalk Interfaces Dialog Box
2. Select the AppleTalk interface that you want to delete from
the Select column.
3. Click DELETE to remove the AppleTalk interface.
Using the CLI
Use the following CLI commands in interface mode to delete an
AppleTalk interface:
(config if-:<interface-name>)# no appletalk cable-range
<cable-range>
(config if-:<interface-name>)# no appletalk address
<network.node>
(config if-:<interface-name>)# no appletalk zone <zone-name>
(config if-:<interface-name>)# no appletalk vlan <vlan-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Creating an AppleTalk Static Route
You can create an AppleTalk static route using the Web Agent or the
CLI.
Using the Web
Agent
To create an AppleTalk static route using the Web Agent:
1. Select Static Route from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Static Route dialog box opens
(Figure 6-125).