Avaya P580 - Manual (Page 586)

17-6 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Using the CLI
To view the Active Alarm Table using the CLI, enter the following
command from Configuration mode:
<configure># show alarms
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Using the Event Subsystem
There are two switch system activity logs:
■
Event Log - stores a large table of events. The size of the
table is user-settable. Because these events are stored in
switch memory, the list is cleared each time the switch
reboots.
■
Shutdown Log - stores the same information as the Event
Log, but generally in a smaller table because the table is
stored in the switch’s nonvolatile RAM (NVRAM). This log
list is particularly useful in assessing the cause of a switch
failure, because the information is retained even after the
switch restarts.
* Note: The following events are now logged in the event log:
— Toggling between the primary and redundant switch
controller or switch element.
— Full functioning of the redundant supervisor after a
failure of the primary supervisor.