Avaya P580 - Manual (Page 669)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 -23
80-Series QoS
For more information about this command, see Chapter 19, “Port,”
in the Command Reference Guide for the Avaya P550R, P580, P880, and
P882 Multiservice Switches, Version 5.3.1.
Setting Up an ACL Rule
Command
Use the access list command to set a rule in an access control list.
The rule that you set up will be applied on all of the ports on the
switch. For more information about using ACL rules, see
“
Classifying Traffic by Layer 3 or Layer 4 Characteristics” on page 8.
* Note: You must enable the access control list on which you want
to set a rule. Only one access control list can be enabled at
a time.
The command syntax is:
Standard ACL
Avaya(configure)#access-list <access-list-name> <access-list-index>
{permit [{use-priority <priority> | use-diffserv [mask] | remark-
diffserv <dscp> [mask] | use-l2}] | deny | fwd1 | fwd2 | fwd3 |
fwd4 | fwd5 | fwd6 | fwd7 | fwd8} {<source-ip-addr> <source-
wildcard> | any | host <source-ip-addr>}
Extended ACL
Avaya(configure)#access-list <access-list-name> <access-list-index>
{permit [{use-priority <priority> | use-diffserv [mask] | remark-
diffserv <dscp> [mask] | use-l2}] | deny | fwd1 | fwd2 | fwd3 |
fwd4 | fwd5 | fwd6 | fwd7 | fwd8} <protocol-id> {<source-ip-addr>
<mod-swport-range> The slot number of a module, and, either
a port number, or a range of port
numbers having the format Px-Py. For
example:
• To specify port 1 on the module in
slot 3, enter 3/1.
• To specify ports 1 through 5 on the
module in slot 3, enter 3/1-5.
If you specify <mod-swport-range>, the
switch displays the QoS settings for the
port or range of ports on the module in
the slot that you specify.
Table 6-149. Keywords, Arguments, and Options
Keyword, Argument
or Option Definition
2 of 2