Avaya P580 - Manual (Page 716)

Appendix B
B-2 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Starting up threads ...
Periodic Task
Network Interface
Front Panel Display
Download
Command Line Parser
Boot process complete - system is now operational.
Boot Software Revision: V5.3
Press Ctrl-P for previous command, Ctrl-N for next command
download Download to FEPROM
feprom Flash EPROM configuration
initLogins Restore default passwords
ip IP Configuration
manuf Get/Set MAC address
nvram Initializes NV RAM-diags run upon reboot
peek Read from memory
ping Ping host [tries] [delay]
poke Write to memory
reset Reset System
Boot>
Password Recovery
The following command is used to reset the switch to the factory
default passwords.
initLogins
Syntax
Boot> initLogins set <0=no change, 1=factory default>
Description
Using a value of zero will retain the current passwords in NVRAM
upon resetting the switch. Using a value of one will restore the
factory default passwords in NVRAM upon resetting the switch.
Downloading New Operational Code
To download new operational code in BOOT mode into APP1 or
APP2.
* Note: The Avaya P550R/P580/P880/P882 Multiservice switch
does not have an IP address assigned to the console
ethernet port when it comes up in BOOT mode.
Therefore, a user must assign an IP address (and default