Ricoh FAX5600L - Manual (Page 102)

1. Make sure that the machine is in standby mode (see page 49).
2. Place your document in the feeder.
3. Either:
❐
Function 1 2
❐
4. Input the telephone number of the first
transfer broadcasting station,
then press
Yes .
. ❐ This machine must be of the same
manufacturer as yours, and it must be
able to act as a Transfer Station.
5. Input the destinations for this transfer broadcaster.
You must use Quick Dials, Speed Dials, or Groups that are stored in the
transfer broadcaster. There is a shorthand notation for this purpose. See the
following examples:
❐ Quick Dial Key 01:
# 0 1 Yes
❐ Speed Dial Code 10:
# * 1 0 Yes
❐ Group 01:
# * * 0 1 Yes
NOTE: You can select up to 30 Transfer Stations, and up to 30 End
Receivers for each Transfer Station. (This number depends on how many
numbers are currently waiting in memory to be dialed. See the table on page
43 for more information concerning the limitations to this feature.)
MEMORY TRANS. OPTIONS
ENTER FAX NUMBER
_
TRANSFER OPTIONS
TRANSF. 1
❐ If you cannot use Function 12, you forgot to store your country code, your fax machine’s
telephone number, or your ID code (Function 61). See pages 83, 84, and 85.
❐ If you have installed the ISDN Option Kit, you must also program the machine’s Own
ISDN G4 and Own ISDN G3 numbers (use Function 61; see pages 233 and 234). Your
G4 Terminal ID and your ISDN subscriber numbers for G4 and G3 must also have been
stored (this is normally done by the service representative when installing the ISDN kit).
_
TRANSFER
TRANSF. 1 12125551234
RECV 1
Note: Do not use the handset.
_
TRANSFER NEXT NO. OR START
TRANSF. 1 12125551234
RECV 2 TRNSF.
_
If you have programmed one of
the User Function Keys to
activate this feature, press that
key and go to step 4.
NETWORKING ADVANCED FEATURES
88