Ricoh FAX5600L - Manual (Page 85)

Using the Stamp
If press the Stamp key to light the Stamp indicator, the machine stamps the
bottom of each page. During memory transmission, the stamp indicates that the
page was successfully stored. For immediate transmission, it shows that the page
was sent successfully. You must switch the stamp on before you press
Start , or
the machine will not stamp the first page.
❐ If you wish the stamp to be at the top of each page instead of at the bottom,
contact your service representative.
Changing the Stamp Home Position Setting
If you wish to change the Stamp home position setting, do the following.
(See page 10 if you need more information about the User Parameter settings
adjustment procedure).
1. Function 6 0 2 2 2 2 9 1
❐ At this time, you can print a User
Parameter List if you press
→
Start
.
2. The settings for switch 00 are now
shown on the bottom line of the display.
The setting that you need to change is
that for digit 0.
3. If you wish to change the setting, press 0 .
4. Finish: Yes Function
USER PARAMETER PRINT LIST
DEFAULT: 01000000
SWITCH00: 01000000 YES TO END
Digit 0
0: The stamp home position is "Off".
If you press the Stamp key to use
the Stamp, the Stamp will be
disabled at the end of the
transmission.
1: The stamp home position is "On".
After the transmission, the Stamp
will stay enabled.
R
O
U
T
IN
E
O
P
E
R
A
T
IO
N
ROUTINE OPERATION SENDING A FAX MESSAGE
71