Ricoh FAX5600L - Manual (Page 233)

OPERATING DIFFICULTIES
Problem Required Action
STANDBY MODE
Nothing happens when the
switch is turned on. Check the power cord. Is it properly plugged into the outlet?
➣
Plug it in firmly
SET DOCUMENT is not
displayed. Switch the power on.
➣
If the Power indicator does not light, check
that the power cord is plugged in.
The display does not show
the Ready condition, or the
machine stops during an
operation. Is the Clear Original or Clear Copy indicator on?
➣
Clear the misfed paper.
See pages 213 and 215.
Is the Load Paper indicator on?
➣
Load paper into the paper tray. See page 194.
Is the Close Cover indicator blinking?
➣
Close all covers indicated on the display.
Is the Add Toner indicator on?
➣
Load a new toner cartridge. See page 195.
Is the Call Service indicator on?
➣
Call your service representative, and
report the message on the display.
TRANSMISSION
The original is not pulled into
the auto document feeder. You did not feed the document far enough into the feeder.
➣
Insert the document into the feeder until it stops.
Retransmit.
Do user maintenance, especially rollers [E] and [J] (see page
203).
➣
If the same problem still exists after user
maintenance, adjust the auto document feeder
mechanism (see page 214).
The machine cannot dial out. The telephone line is disconnected.
➣
Check that the line is connected properly.
The telephone line type setting is incorrect.
➣
Check the telephone line type setting
(see page 28).
The machine cannot dial out
from behind a PBX. The dialed number does not contain an access code or a
pause.
➣
Include the access number and a pause before
the telephone number.
The dialed number did not have enough pauses between the
access number and the telephone number.
➣
Try adding more pauses after the access code.
SO
LV
IN
G
P
R
O
B
L
E
M
S
SOLVING PROBLEMS OPERATING DIFFICULTIES
219