Ricoh FAX5600L - Manual (Page 143)

Memory Lock (Memory Card or Hard Disk Required)
Overview
To use Memory Lock, you must first:
❐ Store a Memory Lock ID.
❐ Switch Memory Lock on.
If Memory Lock is switched on, the machine will not print any incoming fax
messages. They will be kept in memory until you enter the Memory Lock ID that
you previously stored in the machine. Messages received by Confidential
Reception will not be printed when you input the Memory Lock ID.
Cross-reference Confidential Reception: see page 126.
Storing a Memory Lock ID
This can be any four-digit code (using digits 0 to 9 and letters A to F), except 0000
and FFFF.
1. Function 6 0 2 2 2 2
6 1 then ↓ until the screen is as
shown opposite.
2. Yes
3. Input the Memory Lock ID that you will
be using. Example: 6 7 5 4
4. Store the ID: Yes Function
MEMORY LOCK ID
YES TO SET PREVIOUS
NO TO CANCEL NEXT
❐ If no memory card or hard disk is installed,
you will not see this prompt.
MEMORY LOCK ID
ID SETTING
YES TO END
_
MEMORY LOCK ID
YES OR CLR . NO
6754
❐ You must input this ID when you wish to print
an incoming message that was stored under
the protection of the Memory Lock feature.
A
D
V
A
N
C
E
D
F
E
A
T
U
R
E
S
ADVANCED FEATURES RECEPTION
129