Ricoh FAX5600L - Manual (Page 195)

Copying
If you need to make a copy of something, and there is no copier available, use
your fax machine. Just place your original in the feeder, and press the Copy key.
Copying an original is a good way to test contrast and resolution before sending a document,
if you are not sure that the settings that you have chosen are appropriate. The copy made by
your printer shows you how the message would look when received at the other end. If it does
not look good, change the settings and try again.
Cross-references Contrast, Resolution, and Halftone: see page 54.
1. Press Copy .
Note: To cancel copy mode, press Copy again.
2. Use the ← and → arrows on the scroll key to select the required copy
paper size. The number of choices that you have depends on how many pa -
per feed units you have installed.
Example: Press →
3. Place your original in the feeder.
4. Input the number of copies that you need.
Example: 3 copies, press 3 .
5. Start
Note: ❐ If you make a single copy, the original will be reproduced at 400 x 400
dpi, even if the 400 dpi memory option has not been installed.
❐ If you wish to prevent the machine from being used as a copier, call
your service representative. If Copying has been disabled, you will see
COPY MODE IS NOT AVAILABLE if you press Copy.
COPY MODE NO. OF COPIES: 1
SET DOCUMENT
PAPER 8.5x11 8.5x14
COPY MODE NO. OF COPIES: 1
SET DOCUMENT
PAPER 8.5x11 8.5x14
COPY MODE NO. OF COPIES: 1
PRESS START
PAPER 8.5x11 8.5x14
COPY MODE NO. OF COPIES: 3
PRESS START
PAPER 8.5x11 8.5x14
NOTE: Maximum number of copies: 99
A
D
V
A
N
C
E
D
F
E
A
T
U
R
E
S
ADVANCED FEATURES OTHER
181