Ricoh FAX5600L User Manual
Page 154
Switching Forwarding On/Off
Before you use Forwarding, you have to switch it on using Function 81. If it is
switched off, the machine will not forward any incoming fax messages.
After you switch Forwarding on,
(FORWARDING)
is displayed on the operation
panel when the machine is in standby mode.
You can also program a User Function Key to switch Forwarding on/off (use
Function 35, see page 163). If you have done that, just press that key whe never
you wish to switch Forwarding on or off.
Note:
Forwarding cannot be switched on if Memory Lock is switched on. If you
wish to use Forwarding, you must switch Memory Lock off.
1.
Function 6 0 2 2 2 2 8 1
2. Scroll through the list of features with
↑
and
↓
until
FORWARDING
ap-
pears.
3. Change the on/off setting by pressing
←
or
→
.
4. Finish:
Yes Function
Enabling and Disabling the Forwarding Mark
The forwarding mark is printed at the receiving end on the top of each page of the
fax messages that are forwarded from your machine. This mark will help the
operator at the other end to recognize messages that have been forwarded. If you
wish, you can switch this mark off.
To switch the Forwarding Mark on or off, do the following procedure. (See page
10 if you need more information about the User Para meter settings adjustment
procedure).
1.
Function 6 0 2 2 2 2 9 1
2. The settings for switch 00 are now
shown on the bottom line of the display.
PSTN LINE TYPE SELECT
DP
TT
YES
TO END
USER PARAMETER PRINT LIST
DEFAULT:
01000000
SWITCH00:
01000000
YES
TO END
RECEPTION
ADVANCED FEATURES
140