Ricoh FAX5600L - Manual (Page 150)

Programming the Forwarding Feature
This section shows you how to set up your machine to forward incoming fax
messages to another location or locations. After you have done this procedure,
you must switch Forwarding on for it to take effect (using Function 81); see page
140 for how to do this.
Read through these procedures before you use them, as they are a little
complicated.
1. Function 6 0 2 2 2 2
7 5
2. Input a two-digit code from 01 to 05 for a forwarding station number.
❐ The forwarding station is the number that you wish to direct incoming messages to.
Example: 0 2
3. Yes
4. Input the telephone number of this forwarding station.
❐ If your machine is behind a PBX, add the access code before the number,
unless this forwarding station is an extension connected to the same PBX
as your machine.
Then press Yes .
FORWARDING SET FORWARD. CODE
No. PRINT LIST
NO TO CANCEL
_
❐ At this time, you can print a Forwarding
List by pressing →
Start .
FORWARDING YES OR NO
No. 02 DEST. 0 ❐ DEST.0 on the opposite display shows
that there are no RTIs/CSIs stored so far
for this forwarding station.
FORWARDING ENTER FAX NUMBER
No. 02 NO TO CANCEL
_
FORWARDING SELECT
No. 02 DEST. 0
1. RTI PROG 2. RTI YES TO END
_
See page 50 for how to dial.
Do not use the handset.
RECEPTION ADVANCED FEATURES
136