Ricoh FAX5600L - Manual (Page 128)

To switch Restricted Access On or Off, do the following:
If you wish to switch Restricted Access on or off, do the following procedure. (See
page 10 if you need more information about the User Para meter settings
adjustment procedure).
1. Function 6 0 2 2 2 2 9 1
2. The settings for switch 00 are now
shown on the bottom line of the display.
3. Press ↓ until the settings for switch 04
are shown.
The setting that you need to change is
digit 5.
4. If you wish to change the setting, press 5 .
5. Finish: Yes Function
Operating the Machine with Restricted Access Switched On
If you have switched Restricted Access on, the display is as shown below when
the machine is in standby mode.
Before you can use the machine, you must enter your personal code that you
have already registered in the machine. See page 110 for how to store Personal
Codes.
1. Enter your personal code.
Example: 7 3 6 2
2. After a second, the normal standby display will appear, and you can use the
machine. If NOT PROGRAMMED appears, you entered a personal code that is
not stored in the machine.
If you decide that you do not wish to use the machine now, you should return the
machine to Restricted Access standby mode. To do this, either:
❐ Insert a page into the document feeder and remove it immediately.
❐ Press
Function twice.
USER PARAMETER PRINT LIST
DEFAULT: 01000000
SWITCH00: 01000000 YES TO END
Digit 5
0: Restricted Access is Off
1: Restricted Access is On
RESTRICTED ACCESS ENTER CODE
CODE
DEC. 4. 11:50AM
TRANSMISSION ADVANCED FEATURES
114