Ricoh FAX5600L - Manual (Page 252)

Storing a Telephone Number
The following example shows how to store a Quick Dial if the ISDN G4 Option
Type 90 has been installed. The differences between this procedure and the
procedure for the base machine (refer to page 31) are as follows:
❐ You have to select G3 or G4 before you input a Quick Dial or Speed Dial
❐ You may have to input a subaddress for a G4 number if the destination has one.
1. Function 3 1
2. Press the Quick Dial Key that you wish
to program.
Example:
01 Yes
3. Change the line type (G3/G4) to the cor -
rect setting by pressing the G4/G3 Se -
lector key on the operation panel.
4. Enter the telephone number at the op -
eration panel’s ten key pad.
G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause
before the number. For an international number, place a pause after the country code.
G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have
already programmed as the subaddress key. Then enter the subaddress.
QUICK DIAL CHOOSE KEY
PRINT LIST
NO TO CANCEL
_
❐ At this time, you can print a Quick Dial
List if you press →
Start .
QUICK DIAL ENTER FAX NUMBER
01 <G3> NO TO CANCEL
QUICK DIAL ENTER FAX NUMBER
01 <G4> NO TO CANCEL
QUICK DIAL YES OR CLR
.
NO
01 <G4>
7005551234
_
To enter a subaddress, you must use a User Function Key. See page 163 for
how to program a User Function Key using Function 35.
APPENDIX C. ISDN G4 OPTION TYPE 90
238