Ricoh FAX5600L - Manual (Page 111)

Example Procedure (for Quick Reference)
❐ Remote ID: 1111
❐ Transfer Result Report Destination: Speed Dial 04 in your machine.
❐ End Receivers, as programmed in your machine: Quick Dial 01, Speed Dial 02,
Group Dial 03.
1. The requesting party must dial your machine using an external telephone, and
wait for the fax tones.
2. When the fax tones come in, the requesting party must immediately input the
following sequence. (ACK: Wait for the ACK tone)
# - 1111# - 24# - *** - *04# - 01# - *02# - **03# - ## -
3. When the requesting party hears fax tones again, they must press Start.
Notes
❐ The remote ID code must have been programmed earlier.
❐ After entering the ID code, if there is an interval of more than 5 seconds
followed by three short beeps repeated three times, enter the remote ID again.
❐ If you enter the wrong remote ID, you will hear three short beeps. Try to enter
the code again. If you enter the wrong code five times, the remote control
services will not be available until you go back to the machine and reprogram
the ID (this is a security measure to prevent other people getting access to
your machine).
ACK ACK ACK ACK ACK ACK ACK ACK
x3 ACK
End Receiver:
Group Dial 03
Your Machine’s
Remote ID Code Transfer Result
Report Destination:
Speed Dial 04
End Receiver:
Quick Dial 01
End Receiver:
Speed Dial 02
A
D
V
A
N
C
E
D
F
E
A
T
U
R
E
S
ADVANCED FEATURES NETWORKING
97