Yokogawa DAQWORX - Manual (Page 134)

5-24 IM WX102-01E
5.15 Using the Auto Processor
The following Auto Processor functions can be used.
• Automatic conversion function for measurement data files.
To instantly create an Excel/ASCII/Lotus 1-2-3 format after measurement data files are
created with Logger software.
• Auto-printing function for report files.
To print report files after report data have been collected.
• Automatic conversion function for report files.
To instantly create an Excel/ASCII/Lotus 1-2-3 format after report files are created with
Logger software.
Note
Report files are files created with a DA100/DC100/DR, and collected with Logger software. To
create report files it is required to select Logging > Logging Configuration, and check Report
data in the Miscellaneous frame. (See Section 5.2, “Logging Configuration”)
Operating Procedure
1 Select Option > Run Auto Processor from the Logger window to open the Auto
Processor window. If the Auto Processor window is opened, the Auto Processor
icon will appear in the Logger window (see below).
Auto-Processor icon
Automatic conversion for measurement data files
2 Click the DAQ tab.
3 Select the required format(s) for Automatic conversion.
Auto-printing or automatic conversion of report files
4 Click the Report tab.
5 Select Vert. CH or Hor. CH from the Output format frame.
6 In the Automatic conversion frame select the required file format.
7 Click ON or OFF to respectively activate or deactivate conversion or printing of
monthly, daily or hourly reports.
Printer settings
8 Select Auto Processor > Print Setup… to open the dialog box for printer settings.