Yokogawa DAQWORX - Manual (Page 147)

6-11 IM WX102-01E
1
2
3
4
5
6
7
8
9
10
11
Index
Historical V
iewer Software
6.6 Cursor Measurement
It is possible to read time and measurement data values on the X-Axis using two cursors:
cursor A and cursor B. This may be useful if you want to know the time or voltage
difference between two occurrences. Use the cursors as follows:
1 Point the mouse at the position in the waveform display area where you want to
read measurement data. The vertical bar that appears is cursor A. Hold the mouse
and drag the pointer to the next position where you want to read measurement
data. Cursor B gets set when you release the mouse.
Example of cursor display:
Cursor B Cursor A
2 To display the cursor values, select Window > Control, or click the cursor Control
button on the toolbar (below).
Cursor control button
In the cursor Control dialog box you can now read measurement values at the
cursor positions and the value difference between the two cursors positions.
If you wish to accurately adjust the position of a cursor, click the arrow buttons
next to data No. values in the cursor Control dialog box. The cursor will move in
steps of one data item.
Alarm display
Use to move
cursors
3 To erase cursors from the waveform display area, select View > Erase Cursor.
After doing this, no values will remain in the cursor Control dialog box.