16 outputting data divided with cursors, 16 outputting data divided with cursors -29 – Yokogawa DAQWORX User Manual
Page 165
6-29
IM WX102-01E
1
2
3
4
5
6
7
8
9
10
11
Index
Historical V
iewer Software
6.16 Outputting Data Divided with Cursors
This section explains how to use cursors to specify and divide desired data and how to
save them.
1
Set cursor A and B to specify the desired data in the waveform or digital value
display area. For details on cursors see Section 6.6, “Cursor Measurement.”
2
Select Convert > Divide… to open the Divide File dialog box.
3
Range shows the area specified with cursors. To change the range, enter the
desired data numbers directly in the Range textbox.
Note
When no cursors are displayed, the initial range is from 0 to the last recorded data point.
Output file names
4
Click the File button to open the Save As dialog box. Select where to save the file,
enter a file name, and select the type. Click OK to save.
Note
• If no file name is entered, the file will be named: “the original file name.daq.” When there
are files with the same name, a follow-up number will be added to the original file name for
distinction.
For example:
the original file name_0000.daq
(0000 being the follow-up number)
• Do not select external media like floppy disk to save data.
• Do not select save data in a root directory.
• Make sure there is enough memory before saving data.
5
Click OK to save. Click Cancel to close the dialog box without saving.