Yokogawa DAQWORX - Manual (Page 14)

1-6 IM WX102-01E
1.3 Setting up DAQ 32 Plus/DAQ 32 Plus Client
Package
DAQ 32 Plus and DAQ 32 Plus Client Package software is available on both CD-ROM.
Refer to CD-ROM setup below to setup the software. Make sure you have a serial number
for the software beforehand. The serial number is on the CD-ROM case. Be aware that to
start DAQ 32 Plus, and DAQ 32 Plus Client Package, different serial numbers are required.
DAQ 32 Plus
CD-ROM setup
1 Start up either Windows 2000 or Windows XP on your PC.
2 Insert the software CD-ROM in the CD-ROM drive.
3 Double-click the CD-ROM icon on My Computer. An English and a Japanese
folder will appear.
4 If you open the English folder you will find a DAQ 32 Plus, and DAQ 32 Plus Client folder.
5 Open the required folder, then open the Disk 1 folder, and the below box appears.
6 After double-clicking the setup.exe file the software will be executed. Wait and
follow further instructions on the screen.
Note
• Before installing, it is recommended to deactivate virus busters.
• After installing is finished, the below software will be registered in the Start menu.
DAQ 32 Plus: Launcher, Viewer, Remote Monitor, File Utility
DAQ 32 Plus Client Package: Viewer, Remote Monitor, File Utility
• Make sure to install DAQ 32, DAQ 32 Plus, and DAQ 32 Plus Client Package in separate
directories.
• Setting made with DAQ 32 can also be used for DAQ 32 Plus by copying the User and
System folders of DAQ 32 to the directory in which you installed DAQ 32 Plus.
• Only reinstall DAQ 32 Plus after uninstalling the software in the below fashion.
• Uninstalling DAQ 32 Plus:
1 Open Start menu > Settings > Control Panel > Add/Remove Programs.
2 Please make a backup in a separate directory of the following important files:
• All files of the data directories
• All files with extensions .ast, .rst, .cst, .pnl, .set, .txt, for every project.
3 Remove files created after DAQ 32 Plus was installed (left-over data files or
subdirectories) using explorer.
• Don’t set time zones using the Windows system autoexec.bat. (Place the REM command before
commands like TZ=GMTO for autoexec.bat.) To set time zones select the required time zone in
the Windows OS Date/Time Properties setting screen (Start Menu > Settings > Control Panel >
Date/Time), and check the “Automatically adjust clock for daylight saving changes” checkbox.
• In the Windows OS Date/Time Properties setting screen (Start Menu > Settings > Control
Panel > Date/Time) always make sure to check the “Automatically adjust clock for daylight
saving changes” checkbox, even if you do not wish to use daylight saving changes for DAQ
32 plus software. If you don’t check the setting, errors may occur for the DARWIN Daylight
Saving Time function.