Yokogawa DAQWORX - Manual (Page 78)

4-31 IM WX102-01E
1
2
3
4
5
6
7
8
9
10
11
Index
DAR
WIN Hardware Configurator
MATH (for instruments with /M1 option or FDD option only)
• START: Starts computation.
• STOP: Stops computation.
• RESET: Resets computation channel data at the end of completion of the first
computation in case an event takes place.
• CLEAR: Resets computation channel data immediately in case an event takes
place.
• If MATH is selected as a level action, computation will be carried out while an event
is present. Computation will stop when the event is cleared.
MEMORY (for DC100, and DR with FDD option only)
DR with FDD option
• DATA_WR : Saves a data item each time an event occurs, until the specified data
length is reached.
• WR_TRIG : Saves measured/computed data on the built-in RAM disk.
• RD_TRIG : Reads measured/computed data from the built-in RAM disk.
• LD_TRG1-3 : Reads setup data from the built-in RAM disk.
DC100
• DATA_WR : Writes the data for one scan (one data/channel) retained at the
generation of an event. To execute this, it is necessary to set LOGIC
to the writing period.
• TRIG : Generates a trigger to start writing. To execute this, it is necessary to
set TRIG to WRITE TRIG.
• START : Opens a file and starts the writing operation. It is the same function
as the START key on the operation panel.
• PAUSE : In the case of edge action, writing is suspended at the generation of
an event. In the case of level action, by setting the alarm, remote,
relay or internal switch to the event, writing is suspended at the
detection of an event and resumes at the resetting of the event (see
the following figure). Setting the timer, match time or manual function
key to the event repeats suspension and resumption of data writing
at the generation of each event.
• CP_FDD : All files in the built-in RAM disk are copied on a floppydisk. Whether
to cancel files after copying or not depends on the setting in the MEM
SET of the SET UP menu. Copying after a conversion to ASCII
format cannot be done.
• CP_SCS0 to CP_SCS7 :
All files in the built-in RAM disk are copied on a MO, ZIP or PD.
Whether to cancel files after copying or not depends on the setting
in the MEM SET of the SET UP menu. Copying after a conversion to
ASCII format cannot be done.
Displayed only on models with the C/5 option. SCS0 to SCS7
represent the SCSI ID numbers. Check the ID numbers of SCSI
devices that are connected, because ID numbers are displayed even
if there are no devices connected to them.
FLAG (only for Math option models; DC style number. 7+, DA100/DR style
number 8 or higher)
• F01 to 16: Set the flag number (F01 to F16) to 1. F01 to F16 are normally 0. Flags
can be placed in computing equations to hold the computed result using a certain
event as a trigger, or reset to 0.
4.14 Event/Action, Match Time, and Group Settings