System initialization, Display errors – Yokogawa DAQWORX User Manual

Page 46

Advertising
background image

3-8

IM WX102-01E

System Initialization

To initialize the settings of the connected device, do as follows:

1

Click the Diagnostic tab to display the Diagnostic setting screen.

2

To start initialization click the Initialization button (see below), or select Diagnostic

> Initialize from the menubar.

Initialization button

Note

Inputs, Measurement range, etc, will be set to the default values of the currently installed input

modules.

Display Errors

When Sub-Units don’t Appear on the Display

• Verify that the power of the sub-unit is turned ON.

• Verify that the extension cables are properly connected.

• Verify that the unit number of the sub-unit conforms the setting of the rotary switch.

• Verify that after initializing the system no other sub-units have been connected.

When Modules don’t Appear Correctly on Display

• Verify that the configuration of the modules is correct.
• Verify that after initializing the system no other modules have been wired.

When Any of the Following Errors Occur (red background)

The error(s) XX-YY will be displayed. The error YY means the following.

Error
No.

Cause

C0

An input unit which does not match the system configuration has been connected.*1

C1

The module configuration has been altered after initializing the system

81

The number of connected modules exceeds the allowable number

82

Erroneous calibration has been carried out

83

Servicing is required*2

*1 Verify that the style number (for hardware) and release number (for software) match the

following rules:

• module’s style number ≤ main unit’s/sub-unit’s style number.

• main unit’s/sub-unit’s style number ≤ software’s release number.

*2 Contact your nearest sales representative.

3.5 System Reconstruction/Scan/Initialization

Advertising
This manual is related to the following products: