Yokogawa DAQWORX User Manual
Page 186
9-4
IM WX102-01E
9.2
Connecting the Host and Saving Connection
Conditions
When the host PC gets connected for the first time please make the below three settings.
• Connecting host name.
• Port number.
• Step number (the amount of data acquired from the host per connection).
If connection conditions have already been set for a file just open and connect it.
Note
• Connection may get cut off because of circuit problems. Reconnect it.
• If connection is not possible it is likely that the host name isn’t recognized. Register the host
name in the host file.
• To use the Monitor Server or Remote Monitor, your PC must have an Ethernet card, and the
Windows TCP/IP service.
Setting connection conditions
1
Select from the Remote Monitor menubar File > New.
2
Select File > Connect, or File > Configuration… The Connect Settings dialog box
will appear.
3
Enter the Host Name, Port number, System No., and Step number in the
textboxes.
You must enter 0 for the system number.
Note
• The port number must match the port number set for the remote server.
• The initial Port No. value is 50278.
• The initial Step value is 1.
Connecting
4
After all the correct settings are made click the Connect button in the Connect
Settings dialog box to connect the host. Click OK in the Connect Settings dialog
box to save the setting data and to close the dialog box, or Cancel to close the
dialog box without saving settings.
Note
If you clicked OK in step four, it is possible to open the connection by selecting File > Connect,
or by clicking the Connect/Disconnect button on the toolbar.