Yokogawa DAQWORX - Manual (Page 39)

3-1 IM WX102-01E
1
2
3
4
5
6
7
8
9
10
11
Index
Software Configurator
3.1 Using Software Configurator
Starting Software Configurator
Select the Project you want to open. Click the Software Configurator button on the
Launcher toolbar, or right-click the Launcher icon on the taskbar and select Software
Configurator.
Setting Screen
The Software Configurator setting screen should be similar to below illustration.
Click tabs to select
setting pages RS-232-C Settings
The module dipswitch position
necessary for current settings
Present directory to which
data are being saved
GP-IB settings
Change the directory
for saving data
Ethernet settings
RS-422-A/RS-485
settings
Setting Order
Before communicating with the DA100/DC100/DR, please take note of below difference
in setting order.
For communication with GP-IB/RS-232-C/RS-422-A/RS-485
1 Make the Communication settings.
2 Reconstruct the System (Diagnostic > Reconstruct)
3 Make the Diagnostic settings.
For Ethernet communication
1 Set the DA100/DC100/DR IP address, Subnet Mask, and Default Gateway. (See
Network Settings, next Section).
2 Make the Communication settings.
3 Reconstruct the System (Diagnostic > Reconstruct).
4 Make the Diagnostic settings.
For calibration see Chapter 8.
Chapter 3 Software Configurator