Yokogawa DAQWORX - Manual (Page 204)

11-2 IM WX102-01E
11.2 Error Messages and Corrective Actions
Displayed when incorrect settings have been entered or when the instrument is
malfunctioning. If the same problem still occurs after the proper corrective action has
been taken, diagnose the problem using the diagnosis software.
Warning Messages
No. Message/Description
W1102 Converted data file will be overwritten. OK?
W3304 Start Initializing?
W3305 Start Reconstructing?
W3315 Stop Calibration?
W3316 Send Calibration Values?
W3317 60 mV, 200 mV have not been calibrated. Do you want to continue?
W3318 Store Calibration Values?
W3319 Abort Calibration?
W3320 Initial Balance Failed. Retry?
W3332 Close network?
W3333 Set the network address?
W3451 Delete the current Project?
W3671 Please change connected hardware to SET mode.
W3672 Hardware model doesn't match software setting. Continue sending?
W3673 Style numbers don't match. Continue sending?
W3674 Hardware and Software configurations don't match. Continue sending data?
W3675 Hardware and Software options don't match. Continue sending?
W3676 Some data couldn't be read.
W3677 Some existing data were changed.
W3678 This is a reference channel. Channels referring to this channel will be changed too!
W3679 Settings of other power module channels will be changed too!
W3680 Some channels out of the copy range will be changed too!
W3681 Some channels can't be copied.
W3682 Writing operation was changed.
W3683 Following the change of temperature unit, SET (Regular) settings have been initialized.
W3684 The digital print settings of some measurement and Math channels have been changed.
W3685 The relay settings of some measurement and math channels were set OFF.
W3686
Some Event/Action settings have been changed.
Error Messages <Common>
No. Message/Corrective action
E0001 Insufficient Memory.
Exit other programs and restart, or reboot the OS and restart the program.
E0002 Insufficient Memory. Please close at once.
Exit other programs and restart, or reboot the OS and restart the program.
E0003 Can’t open shared memory.
Exit other programs and restart, or reboot the OS and restart the program.
E0004 Incorrect License number.
Reinstall with correct License number.
E0101 Please use DAQ32 launcher to open.
Please use DAQ32 Plus launcher to open.
Run the program from the launcher.
E0201 Can’t open. No YOKOGAWA binary file.
Cannot handle this file.
E0202 Can’t open. No DARWIN binary file.
Cannot handle this file.
E0203 No data available.
Cannot handle this file.
E0211 Can’t write to file.
Check the directory’s free space. Check that other programs are not using the file.