GW Instek PEL-2000 Series Programming User Manual - Manual (Page 104)

PEL-2000 Programming Manual
104
Example :RES:L1 10 Sets CR static mode A
Value to 10 ohms,
depending on the
specific range
Query Syntax :RESistance[:STATic]:L1/L2? [MAX|MIN]
Return Parameter <NR2> [MAX|MIN] Resistance
1 unit = 1 ohm/1 k ohm Returns the resistance of
the A or B Value.
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :RES:L1? MAX
300 Returns the maximum
resistance allowed for
the channel. (PEL-2020)
:RESistance[:STATic]:RISE/FALL
Channel Specific
Command
Description Sets the rising/falling slew rate for CR mode. The
command applies to the current mode
(static/dynamic) and the current range
(High/Low)
Syntax :RESistance[:STATic]:RISE/FALL <NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew rate
RISE/FALL 0.8A/uS Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL .8 Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example :RES:RISE 0.1 Sets the rising slew rate
to 0.1A/uS.
Query Syntax :RESistance:RISE/FALL? [MIN|MAX]