GW Instek PEL-2000 Series Programming User Manual - Manual (Page 49)

COMMAND DETAILS
49
Example :CONF:RESP 0 Response set to normal.
Query Syntax : CONFigure:RESPonse?
Return Parameter <NR1> Response
0 Normal
1 Fast
Query Example :CONF:RESP?
1 Response is Fast.
:CONFigure:RESEt
Channel Specific
Command
Description Recalls the original factory default settings.
Syntax :CONFigure:RESEt
Example :CONF:RESE
:CONFigure:GROup:UNITs
Channel Specific
Command
Description Sets or queries the number of single channel load
modules (PEL-2040 or PEL-2041) that can be used
in the parallel mode.
Syntax CONFigure:GROup:UNITs <NRf>|MIN|MAX
Parameter <NRf> Number of units
MIN Sets to the minimum
number
MAX Sets to the maximum
number
Example CONF:GRO:UNIT 2 Sets the parallel mode to 2
units.
Query Syntax CONFigure:GROup:UNITs? [MIN|MAX]
Return Parameter <NR1> Returns the number of
units
MAX/MIN Returns the allowable
maximum and minimum.