GW Instek PEL-2000 Series Programming User Manual - Manual (Page 154)

PEL-2000 Programming Manual
154
Parameter OFF/0 Off
ON/1 On
Example :SEQ:END:LOAD 0 On End Load = Off.
Query Syntax :SEQuence:END:LOAD?
Return Parameter <NR1> On End Load
0 Off
1 On
Query Example :SEQ:END:LOAD?
1 On End Load is On.
:SEQuence:VOLTage:RANGe
Channel Specific
Command
Description Sets the sequence CC voltage range.
Syntax :SEQuence:VOLTage:RANGe <NRf>[V]|L|H
Parameter <NRf>[ V] , L, H Range
16 Low range*
80V High range*
L Low range
H High range
*Load module dependent, PEL-2020 shown.
Example :SEQ:VOLT:RANG L Sets the range to Low for
the channel.
Query Syntax :SEQuence:VOLTage:RANGe?
Return Parameter <NR2> Range
16 Low PEL-2020,2030,2040
125 Low PEL-2041
80 High PEL-2020,2030,2040
500 High PEL-2041