GW Instek PEL-2000 Series Programming User Manual - Manual (Page 155)

COMMAND DETAILS
155
Query Example :SEQ:VOLT:RANG?
500 Returns the voltage
range. In this case high
for the PEL-2041.
:SEQuence:LOOP:STARt
Channel Specific
Command
Description Determines from which point to start repeating
(looping) the sequence from when using the
SEQuence:REPeat command.
Syntax :SEQuence:LOOP:STARt <NR1>
Parameter <NR1> Start loop from
1~last point 1st~ last point.
Example :SEQ:LOOP:STAR 2 Loop from point 2.
Query Syntax :SEQuence:LOOP:STARt?
Return Parameter <NR1> Point
1~last point Returns the point that the
loop will start from.
Query Example :SEQ:LOOP:STAR?
2 The loop starts at point
2.
:SEQuence:CHANnel:TIME
Channel Specific
Command
Description Sets which channel duration time the specific
channel will use.
Syntax :SEQuence:CHANnel:TIME <NR1>
Parameter <NR1>1~max channels Duration Time Settings
1 Use channel 1
2 etc Use channel 2 etc
Example :SEQ:CHAN:TIME 3 Set the specific channel
to use the channel
duration time of channel
3.