GW Instek PEL-2000 Series Programming User Manual - Manual (Page 112)

PEL-2000 Programming Manual
112
L1/L2 MIN Sets L1 or L2 to the
minimum level for the
specific channel.
L1/L2 MAX Sets L1 or L2 to the
maximum level for the
specific channel.
Example :RES:DYN:HIGH:L1 10 In high range CR
dynamic mode, Set L1
(level 1) to 10 ohms.
Query Syntax :RESistance:DYNamic:HIGH:L1/L2? [MIN|MAX]
Return Parameter <NR2> [MAX|MIN] Resistance
1 unit= 1 ohm Returns the resistance of
Level 1/ 2 (L1/L2).
Query Example :RES:DYN:HIGH:L2? MAX
15000.0 Returns the maximum
resistance allowed for
the channel. (PEL-2020)
:RESistance:DYNamic:HIGH:RISE/FALL
Channel Specific
Command
Description Sets the high range rising/falling slew rate for CR
dynamic mode for the specific channel.
Syntax :RESistance:DYNamic:HIGH:RISE/FALL
<NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew Rate
RISE/FALL 0.8A/uS Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL 1 Sets the rising/falling slew
rate to 1A/uS
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example :RES:DYN:HIGH:RISE 1.1 Sets the rising slew rate
to 1.1A/uS.