GW Instek PEL-2000 Series Programming User Manual - Manual (Page 39)

COMMAND DETAILS
39
Example :CONF:VOLT:ON 30MV Set Von to 30 millivolts.
Query Syntax :CONFigure:VOLTage:ON?
Return Parameter <NR2> I unit = I volt Von value (volts)
1 1 volts
Query Example :CONF:VOLT:ON?
0.03 Von is set as 30 millivolts
(0.03 volts).
:CONFigure:VOLTage:RANGe
Channel Specific
Command
Description Sets Voltage range for CC mode.
Syntax :CONFigure:VOLTage:RANGe <NRf>[V]|L|H
Parameter <NRf>[ V] , L, H Range
16 Low range*
80V High range*
L Low range
H High range
*Load module dependent, PEL-2020 shown.
Example :CONF:VOLT:RANG L Sets the range to Low for
the channel.
Query Syntax :CONFigure:VOLTage:RANGe?
Return Parameter <NR2> Range
16 Low PEL-2020,2030,2040
125 Low PEL-2041
80 High PEL-2020,2030,2040
500 High PEL-2041
Query Example :CONF:VOLT:RANG?
500 Returns the voltage
range. In this case high
for the PEL-2041.