GW Instek PEL-2000 Series Programming User Manual - Manual (Page 150)

PEL-2000 Programming Manual
150
Query Example :SEQ:EDIT:POIN?
3 The current point is 3.
:SEQuence:END
Channel Specific
Command
Description Sets the number of points in the sequence.
Syntax :SEQuence:END <NR1>
Parameter <NR1> Points
1~120 1~120.
Example :SEQ:END 5 Sets the max number of
points to 5.
Query Syntax :SEQuence:END?
Return Parameter <NR1> Points
1~120 1~120
Query Example :SEQ:END?
5 There are 5 points in the
sequence.
:SEQuence:POINt:RESistance
Channel Specific
Command
Description Sets the resistance value for the current point. CR
mode only.
Syntax :SEQuence:POINt:RESistance
<NRf>[OHM]|MIN|MAX
Parameter <NRf>[OHM], MIN, MAX Resistance value
100 100Ω
100 OHM 100Ω
MAX/MIN Maximum or minimum
value.
Example :SEQ:POIN:RES 100 Sets the resistance to 100.
Query Syntax :SEQuence:POINt::RESistance? [MAX|MIN]
Return Parameter <NR1> Resistance Value