GW Instek PEL-2000 Series Programming User Manual - Manual (Page 161)

COMMAND DETAILS
161
Command Error Codes
Description The PEL has a number of specific error codes. Use
the SYSTem:ERRor command to recall the error
codes.
-102 Syntax error.
An unrecognized command or data
type was encountered.
-109 Missing parameter
The command header requires
more parameters than was received.
-122 Data out of range
The data is outside the allowed
range.
-128 Numeric data not allowed
The command does not accept
numerical data/parameters
-200 Execution error
Generic execution error.
-144 Character Data too long
The character data contains more
than twelve characters
-151 Invalid String
The string data received is invalid
-148 Character data not allowed
The command does not accept
character data
-138 Suffix not allowed
A command does not accept
suffixes/the suffix type.