GW Instek PEL-2000 Series Programming User Manual - Manual (Page 57)

COMMAND DETAILS
57
Query Example :CURR:STAT:REC?
0 A Value is active.
:CURRent:STATic:L1/L2
Channel Specific
Command
Description Sets the A/B Value for constant current static
mode, where L1 is A Value and L2 is B Value. The
command is range dependant. If the current range
is Low, then the command will only apply to the
low range settings.
Syntax :CURRent:STATic:L1|L2 <NRf+>[A]
Parameter <NRf+>[A]
L1 1 Sets A Value to 1 Amp.
L2 2 Sets B Value to 2 Amps.
L1 1A Sets A Value to 1 Amp.
(single channel only)
L1 MIN Sets A Value to the
minimum level for the
specific channel.
L1 MAX Sets A Value to the
maximum Level for the
specific channel.
Example :CURR:STAT:L1 1 Sets A Value to 1 amp
for the current range
Query Syntax :CURRent:STATic:L1?/L2? [MAX|MIN]
Return Parameter <NR2> [MAX|MIN] Current
1 unit = 1 amp Returns the current of the
A Value (L1) or B Value
(L2).
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :CURR:STAT:L2? MAX
10.2 Returns the maximum
current allowed for the
channel. (PEL-2020)