HP XP Racks - Manual (Page 587)

6. Press the F4=Discover key.
The Scan Device Address Extent panel appears.
7. Specify / for Device Num or Volser to set the scan target, and specify the scan range in Start
and End.
8. Press the F6=Scan key.
The scan result appears.
9. Repeat steps 7 and 8 to perform a scan with another scope.
10. After the scan has completed, press the F3=Exit key.
The Discover HP Storage Arrays panel displays the list of detected storage system serial
numbers found through scanning.
11. (Optional) Enter an overview in Description.
12. Specify s in the AC column to display detailed information.
In the Control Unit Selection List panel, the scan result appears for each CU.
13. Specify s in the AC column to display further detailed information.
The Command Control Address (CCA) Selection List panel displays the scanning results within
the CU by CCA (device).
14. Press the F3=Exit key to save the scan result into a disk configuration definition file.
Disk configuration definition file name: prefix.DSK.SNnnnnn.dad-id
In the configuration example in “Volume configuration example for acquiring device information
” (page 583) , a disk configuration definition file named CONFIG01.DSK.SN14001.LA is
generated.
Transferring a disk configuration definition file from the secondary site to the primary
site
To transfer the disk configuration definition file of the secondary site to the primary site:
Acquiring volume information 587